Section (8) fsck.minix
fsck.minix — check consistency of Minix filesystem
fsck.minix performs a consistency check for the Linux MINIX filesystem.
The program assumes the filesystem is quiescent. fsck.minix should not be used on a mounted device unless you can be sure nobody is writing to it. Remember that the kernel can write to device when it searches for files.
will usually have the following form:
/dev/hda[1–63] IDE disk 1 /dev/hdb[1–63] IDE disk 2 /dev/sda[1–15] SCSI disk 1 /dev/sdb[1–15] SCSI disk 2
If the filesystem was changed, i.e., repaired, then fsck.minix will print FILE SYSTEM HAS CHANGED and will sync(2) three times before exiting. There is no need to reboot after check.
fsck.minix should not be used on a mounted filesystem. Using fsck.minix on a mounted filesystem is very dangerous, due to the possibility that deleted files are still in use, and can seriously damage a perfectly good filesystem! If you absolutely have to run fsck.minix on a mounted filesystem, such as the root filesystem, make sure nothing is writing to the disk, and that no files are zombies waiting for deletion.
List all filenames.
Perform interactive repairs.
Perform automatic repairs. This option implies
−−repairand serves to answer all of the questions asked with the default. Note that this can be extremely dangerous in the case of extensive filesystem damage.
Output super-block information.
Activate MINIX-like mode not cleared warnings.
Force a filesystem check even if the filesystem was marked as valid. Marking is done by the kernel when the filesystem is unmounted.
Display version information and exit.
Display help text and exit.
There are numerous diagnostic messages. The ones mentioned here are the most commonly seen in normal usage.
If the device does not exist, fsck.minix will print unable to read super block. If the device exists, but is not a MINIX filesystem, fsck.minix will print bad magic number in super-block.
The exit code returned by fsck.minix is the sum of the following:
Filesystem errors corrected, system should be rebooted if filesystem was mounted
Filesystem errors left uncorrected
Combination of exit codes 3 and 4
Usage or syntax error
Error code values by Rik Faith
Added support for filesystem valid flag: Dr. Wettstein
Check to prevent fsck of mounted filesystem added by Daniel Quinlan
Portability patch by Russell King
The fsck.minix command is part of the util-linux package and is available from Linux Kernel Archive
Copyright 1992, 1993, 1994 Rickard E. Faith (faithcs.unc.edu)
May be freely distributed.