Section (8) ldattach
ldattach — attach a line discipline to a serial line
−i iflag ] [
−s speed ] ldisc device
daemon opens the specified
device file (which should refer
to a serial device) and attaches the line discipline
ldisc to it for
processing of the sent and/or received data. It then goes
into the background keeping the device open so that the line
discipline stays loaded.
The line discipline
ldisc may be specified either
by name or by number.
In order to detach the line discipline, kill(1) the ldattach process.
With no arguments, ldattach prints usage information.
Depending on the kernel release, the following line disciplines are supported:
The default line discipline, providing transparent operation (raw mode) as well as the habitual terminal line editing capabilities (cooked mode).
Serial Line IP (SLIP) protocol processor for transmitting TCP/IP packets over serial lines.
Device driver for RS232 connected pointing devices (serial mice).
Point to Point Protocol (PPP) processor for transmitting network packets over serial lines.
Line driver for transmitting X.25 packets over asynchronous serial lines.
Driver for Simatic R3964 module.
Linux IrDa (infrared data transmission) driver - see http://irda.sourceforge.net/
Synchronous HDLC driver.
Synchronous PPP driver.
Bluetooth HCI UART driver.
Driver for Siemens Gigaset M101 serial DECT adapter.
Driver for serial line Pulse Per Second (PPS) source.
Driver for GSM 07.10 multiplexing protocol modem (CMUX).
- −1, −−onestopbit
Set the number of stop bits of the serial line to one.
- −2, −−twostopbits
Set the number of stop bits of the serial line to two.
- −7, −−sevenbits
Set the character size of the serial line to 7 bits.
- −8, −−eightbits
Set the character size of the serial line to 8 bits.
Keep ldattach in the foreground so that it can be interrupted or debugged, and to print verbose messages about its progress to standard error output.
Set the parity of the serial line to even.
−i, −−iflag [−]
Set the specified bits in the c_iflag word of the serial line. The given value may be a number or a symbolic name. If value is prefixed by a minus sign, the specified bits are cleared instead. Several comma-separated values may be given in order to set and clear multiple bits.
Set the parity of the serial line to none.
Set the parity of the serial line to odd.
Set the speed (the baud rate) of the serial line to the specified value.
Define an intro command that is sent through the serial line before the invocation of ldattach. E.g. in conjunction with line discipline GSM0710, the command _zsingle_quotesz_AT+CMUX=0 _zsingle_quotesz_ is commonly suitable to switch the modem into the CMUX mode.
Sleep for value seconds before the invocation of ldattach. Default is one second.
Display version information and exit.
Display help text and exit.
Tilman Schmidt ([email protected])