Section (8) slapindex

Linux manual pages Section 8  


slapindex — Reindex entries in a SLAPD database


SBINDIR/slapindex [ −b suffix ] [−c] [ −d debug−level ] [ −f slapd.conf ] [ −F confdir ] [−g] [ −n dbnum ] [ −o option[= value] ] [−q] [−t] [−v] [ attr [ ... ] ]


Slapindex is used to regenerate slapd(8) indices based upon the current contents of a database. It opens the given database determined by the database number or suffix and updates the indices for all values of all attributes of all entries. If a list of specific attributes is provided on the command line, only the indices for those attributes will be regenerated. Databases configured as subordinate of this one are also re-indexed, unless −g is specified.

All files eventually created by slapindex will belong to the identity slapindex is run as, so make sure you either run slapindex with the same identity slapd(8) will be run as (see option −u in slapd(8)), or change file ownership before running slapd(8).


−b suffix

Use the specified suffix to determine which database to generate output for. The −b cannot be used in conjunction with the −n option.


enable continue (ignore errors) mode.

−d debug−level

enable debugging messages as defined by the specified debug-level; see slapd(8) for details.

−f slapd.conf

specify an alternative slapd.conf(5) file.

−F confdir

specify a config directory. If both −f and −F are specified, the config file will be read and converted to config directory format and written to the specified directory. If neither option is specified, an attempt to read the default config directory will be made before trying to use the default config file. If a valid config directory exists then the default config file is ignored.


disable subordinate gluing. Only the specified database will be processed, and not its glued subordinates (if any).

−n dbnum

Generate output for the dbnum-th database listed in the configuration file. The config database slapd-config(5), is always the first database, so use −n 0

The −n cannot be used in conjunction with the −b option.

−o option[=value]

Specify an option with a(n optional) value. Possible generic options/values are:

              syslog=<subsystems>  (see `−s_zsingle_quotesz_ in slapd(8))
              syslog−level=<level> (see `−S_zsingle_quotesz_ in slapd(8))
              syslog−user=<user>   (see `−l_zsingle_quotesz_ in slapd(8))

enable quick (fewer integrity checks) mode. Performs no consistency checks when writing the database. Improves indexing time, however the database will most likely be unusable if any errors or interruptions occur.


enable truncate mode. Truncates (empties) an index database before indexing any entries. May only be used with Quick mode.


enable verbose mode.


Your slapd(8) should not be running (at least, not in read-write mode) when you do this to ensure consistency of the database.

This command provides ample opportunity for the user to obtain and drink their favorite beverage.


To reindex your SLAPD database, give the command:


To regenerate the index for only a specific attribute, e.g. uid, give the command:

        SBINDIR/slapindex uid


ldap(3), ldif(5), slapadd(8), ldapadd(1), slapd(8)

OpenLDAP Administrator_zsingle_quotesz_s Guide (


OpenLDAP Software is developed and maintained by The OpenLDAP Project <>. OpenLDAP Software is derived from the University of Michigan LDAP 3.3 Release.

See the following documents: COPYRIGHTLICENSE